With this simple clockcontrolled timer, you will
never again miss your favourite TV or radio programme. The
TV or radio will switch on automatically at the time preset by you and
will remain ‘on’ until the power supply fails or is disconnected.
The circuit uses the AC signals generated at the buzzer terminals of an
alarm clock. The AC signals are amplified by transistors T1 and T2 &
never again miss your favourite TV or radio programme. The
TV or radio will switch on automatically at the time preset by you and
will remain ‘on’ until the power supply fails or is disconnected.
The circuit uses the AC signals generated at the buzzer terminals of an
alarm clock. The AC signals are amplified by transistors T1 and T2 &
the amplified output from the emitter of T2 is fed to the inverting input of
negative-voltage comparator IC LM311 (IC1). The non-inverting input of IC1
gets a presettable voltage through preset VR1. The inverting and non-inverting
gets a presettable voltage through preset VR1. The inverting and non-inverting
inputs of LM311 are different from other op-amps and it outputs sink current
through pin 7 or source current through pin 1.
When pin 3 of IC1 is at a higher voltage than pin 2, its output sinks
as indicated by LED1. This gives a short negative pulse to the monostable
wired around timer NE555. Resistor R5 keeps trigger pin 2 of IC2 high.
The short-interval monostable outputs a high signal for a brief period to the
gate of SCR1 (BT169) and relay RL1 energises. The latching action of SCR1
keeps the relay pulled even when the output of the monostable turns low.
The relay can be de-energised by disconnecting the supply to the circuit switch s1
The circuit works off a 9V battery.
Assemble it on a general-purpose PCB and enclose in a suitable
cabinet. Provide an AC outlet in the cabinet to switch on the appliance using
the circuit. As mentioned earlier, the input signal is obtained from the
buzzer terminals of the clock. Remove the small buzzer of the clock and connect
point ‘A’ to the positive terminal and point ‘B’ to the negative terminal
of the buzzer. Connect the mains AC terminal outlet to the normally-
opened (N/O) contact of relay RL1. So when the relay energises,
through pin 7 or source current through pin 1.
When pin 3 of IC1 is at a higher voltage than pin 2, its output sinks
as indicated by LED1. This gives a short negative pulse to the monostable
wired around timer NE555. Resistor R5 keeps trigger pin 2 of IC2 high.
The short-interval monostable outputs a high signal for a brief period to the
gate of SCR1 (BT169) and relay RL1 energises. The latching action of SCR1
keeps the relay pulled even when the output of the monostable turns low.
The relay can be de-energised by disconnecting the supply to the circuit switch s1
The circuit works off a 9V battery.
Assemble it on a general-purpose PCB and enclose in a suitable
cabinet. Provide an AC outlet in the cabinet to switch on the appliance using
the circuit. As mentioned earlier, the input signal is obtained from the
buzzer terminals of the clock. Remove the small buzzer of the clock and connect
point ‘A’ to the positive terminal and point ‘B’ to the negative terminal
of the buzzer. Connect the mains AC terminal outlet to the normally-
opened (N/O) contact of relay RL1. So when the relay energises,
230V AC operates the connected appliance. Set the desired time in the clock by
adjusting the alarm set-up and switch on the circuit. When the set time
reaches, the appliance will switch on automatically. The circuit can also be
connected to digital clocks.
reaches, the appliance will switch on automatically. The circuit can also be
connected to digital clocks.
0 comments:
Post a Comment
Thanks for your Valuable comment